ETC Eos Titanium, Eos, and Gio v2.0.0 - Manual (Page 246)

228 Eos Titanium, Eos, and Gio Operations Manual
Record Filters
Record filters are used to select specific parameter data to store to record targets. When no filters
are selected, all parameters can be stored, as appropriate to the [Record], [Record Only], and
selective record action used.
Record filters are applied from the CIA using the following buttons: [Filter], the parameter buttons
in the CIA, and the parameter category buttons.
The parameter category buttons can be used to select filters, as follows:
• Intensity (enables recording intensity data)
• Focus (enables recording pan and tilt)
• Color (enables recording color data)
• Beam (enables recording all beam data)
To apply record filters by category:
Step 1: Press and hold [Filters]. The parameter buttons change to display filter selection.
Step 2: Press the parameter category softkey {Intensity/Focus/Color/Beam} for the
category you want to include in the record target. All parameters in that category will
be highlighted and “Filter On” will appear above the softkey.
Step 3: Release [Filters]. The buttons return to their normal appearance.
In subsequent record functions, only the filtered categories will be recorded. You may apply multiple
category filters at once. Remember that applying all filters and no filters yields the same effect.
Partial Filters
If you do not want an entire category to be recorded, you may apply parameter specific filters
(partial filters) instead.
To apply partial filters:
Step 1: Press and hold [Filters]. The parameter buttons change to display filter selection.
Step 2: Press the parameter touchbutton (for example {Zoom}) for the parameter you want
to include in the record target. That parameter will be highlighted and “Filter On” will
appear above the softkey.
Step 3: Release [Filters]. The buttons return to their normal appearance.
In subsequent record functions, only the filtered parameters will be recorded. You may apply as
many partial filters at once, as you wish. Any unfiltered parameters will not be included in record
actions. In live, unfiltered parameter data is displayed in its proper color, but a gray “n” (indicating
null data) will appear in the upper right corner of the parameter’s field.
N o t e : When storing show data, applied filters are highlighted and allow the associated
parameters to be stored in record targets.
When filters are deselected (not highlighted), they prohibit storing the associated
parameters.
There is no difference between having all filters selected and having no filters
selected (default). In either state, all parameters are available for recording.