ETC Eos Titanium, Eos, and Gio v2.0.0 - Manual (Page 414)

396 Eos Titanium, Eos, and Gio Operations Manual
Remote Software Installation
Within a multi-console system, you can now remotely install software to all devices.
In the ECU, go to Setting> General> Automatically Update Software to enable. Once enabled,
the devices can be remotely updated with the next version of software. Devices will receive the
software update from the Primary. When you install software on the Primary, the software will first
be copied to its hard drive.
With the devices synchronized with the Primary, install the new version of software onto the
Primary. All devices will lose their connection with the Primary at that time. When the Primary
comes back online after installing the software, all the connected devices will be forced to update
their software before they can reconnect with the Primary.
Remote Power On/Off
In a multi-console system, it is possible to power on and off devices remotely. Remote Power On
and Remote Power Off must be enabled on each device before it can receive the power on and off
commands. In the ECU go to Settings> Network> Enable Remote Power Off and Enable
Remote Power On. The default setting for both is “Disabled”.
The Remote Power commands are sent from the browser. The command for Power On is sent from
Browser> Network> Power On MultiConsole System, and the command for Power Off is from
Browser> Network> Power Off MultiConsole System.
N o t e : All devices must be upgraded to version 1.9 before remote software installation is
available.
N o t e : Eos desks cannot be remotely powered on.
N o t e : Only devices that synchronize with the Primary will be available for Remote Power
On and Off.