ETC Eos Titanium, Eos, and Gio v2.0.0 - Manual (Page 148)

130 Eos Titanium, Eos, and Gio Operations Manual
Setup. The default is 30. When any other encoder is moved one revolution, the parameter will
change by the set percentage of its entire range. The default is 35.
The settings for {Encoder Degrees Per Revolution} and {Encoder Percent Per Revolution} are
stored with the showfile. Starting a new file will reset the two settings. Whether or not acceleration
is disabled or enabled is not stored with the showfile.
{Face Panel Keypad}
Auto Repeat
This setting allows you to adjust the auto repeat settings (delay and speed) for the facepanel
keypad.
Spacebar [Go]
You can enable the spacebar on an external keyboard as the hotkey for [Go]. By default, it is
“Disabled”.
Hide Mouse
With hide mouse enabled, if the mouse is left idle for 10 seconds, the cursor will go away. Once the
mouse is used again, the cursor will return. By default, this is “Disabled”.
{Displays}
This desk setting button gives you access to the Eos display settings.
High Contrast Display
This touchbutton toggles the setting between “Enabled” and “Disabled”. When enabled, high-
contrast brightens the magenta used to show tracked values.
The default setting for this is “Disabled”.
Show Reference Labels
This touchbutton toggles the setting between “Enabled” and
“Disabled”. When enabled, referenced record targets (such
as presets or palettes) with labels will have their labels
displayed in the live/blind display rather than their target
type and number. [Shift] & [Label] can be used to
temporally toggle between views.
The default setting for this is “Disabled”.
N o t e : Acceleration is disabled in Eos Ti and Gio.
Reference
labels