ETC Eos Titanium, Eos, and Gio v2.0.0 User Manual
Page 71
4
System Basics
53
•
P . . . . . . . . . . . . . . . . . . .Indicates the channel is parked.
•
Ph. . . . . . . . . . . . . . . . . .Indicates the channel is at a preheat level.
•
Pr . . . . . . . . . . . . . . . . . .Indicates that the value is referenced to a preset. This text is
followed by a number, indicating which preset is being
referenced. The preset label may also be shown if this setting
is enabled (see
Show Reference Labels, page 130
). Holding
down [Shift] & [Label] will toggle between the preset label
and preset number.
•
Q. . . . . . . . . . . . . . . . . . .Found in the non-intensity categories of a marked channel.
The “Q” is followed by a number indicating which cue the
mark is in preparation for.
•
t . . . . . . . . . . . . . . . . . . .The channel has discrete (parameter/category-specific)
timing.
•
+ . . . . . . . . . . . . . . . . . . .Found in place of parameter data in summary view. Indicates
that not all parameters in that category are at the same value.
This indicator is found only in the summary view or in table
views when the parameters are collapsed into a category
view.
•
! . . . . . . . . . . . . . . . . . . .Indicates an ACN, RDM, or dimmer error.
•
ND . . . . . . . . . . . . . . . . .Indicates that a channel has been patched as a non-dim
fixture type.
•
S . . . . . . . . . . . . . . . . . . .Indicates that a channel is stored to a shielded submaster.
•
R. . . . . . . . . . . . . . . . . . .Indicates a manual reference override. Manual changes have
been made that override a previously stored reference (such
as to a palette or preset). Once recorded, the reference will
be broken. If updated, the referenced target will be updated
as well, unless otherwise instructed.
•
M . . . . . . . . . . . . . . . . . .Indicates a mark is placed, but manual, and must be stored.
Is blue when stored.”m” indicates cue is not marking.