ETC Eos Titanium, Eos, and Gio v2.0.0 - Manual (Page 175)

8
Basic Manual Control 157
• [Sneak] <Time> [3] [Enter] - restores all channels with manual values to their background
state in 3 seconds.
• [Select Active] [Sneak] [Enter] - selects all channels with intensity above zero and restores
them to their background state, using default sneak times.
• [Group] [5] <Color Palette> [9] [Sneak] [Enter] - selects group 5 and sneaks it to color
palette 9 using default sneak time.
• [Group] [3] [At] <Color Palette> [1] [Sneak] <Time> [7] [Enter] - selects group 3 and
sneaks it to color palette 1 in 7 seconds.
• [Sub] [4] [At] [5] [0] [Sneak] [2] [Enter] - selects submaster 4 and sneaks it to 50% in 2
seconds.
• [Chan][1] [Sneak] {Preset 1}- selects channel 1 and sneaks it to preset 1 using default sneak
time.
• [Chan][2][Sneak]<Time>[2]{Intensity Palette 3}- selects channel 2 and sneaks it to
intensity palette 3 in 2 seconds.
• [Shift] & [Sneak] - makes any manual data unmanual. The values will remain but they will no
longer be available for [Update] or [Record Only] operations. When used with an empty
command line, this will affect any and all manual data. When used with a channel selection,
only those channels will be affected.
Flip
The {Flip} feature is used to invert the pan and tilt values of selected channels to achieve the same
focus position from the opposite yoke position. This allows you to correctly focus a fixture that may
be at the end of its pan or tilt range or to correct a fade that may be moving in an undesired
direction. {Flip} is located on the encoder touch screen, near the pan and tilt encoders.
The following example illustrates the use of {Flip}:
• [channel list] {Flip}
“Select” Keys
Select Last
The [Select Last] key allows you to reselect whatever the previous channel selection was. This
includes multiple channel selections, groups, etc. Using [Select Last] [Select Last], Eos will recall
your last command line and leave it unterminated for further operation. [Shift] + [Select Last] can
be used to recall the last channel selection and any parameters without the last value for those
parameters.
N o t e : When recalling a reference from the direct selects to use with the sneak
command, the sneak command has to be entered before the reference.
N o t e : If any manual control action is taken immediately after a [Record], [Record Only],
or [Update] command, the previously selected channels will automatically be
reselected.