N o t e – ETC Eos Titanium, Eos, and Gio v2.0.0 User Manual
Page 443
F
Universal Fader Wings
425
then press down gently on the wing on the right until it is fully seated. This should be
a smooth connection but may require a little force.
Step 6:
Repeat above procedure to attach another wing to the right end of the pair, if desired.
Step 7:
Re-insert screws to secure wings together and secure the bumpers to the sides of the
wings.
Connect Universal Fader Wing(s) to Console with USB Cable
Step 1:
With the console power off, attach the USB A to B cable (provided) between the
console and one wing as shown above. If multiple wings are joined, only one power
and one USB connection is required for all joined wings.
Step 2:
Using the power supply adapter kit, connect the fader wing to a power source.
Step 3:
It is recommended that you run the power and USB cables through the strain relief
included on the back of the wings.
Step 4:
Turn the console on.
N o t e :
When connecting fader wings to Eos Ti or Gio, they must be plugged into a USB
1.1 hub and then connected to an USB port on Eos Ti / Gio.
connect to USB
on the console
connect PS364-F
power supply
cable
(included)
connect
USB cable
(included)