ETC Eos Titanium, Eos, and Gio v2.0.0 - Manual (Page 85)

4
System Basics 67
To the left of the encoder touchscreen are six hardkeys
that are for encoder control. From top to bottom, these
encoder paging keys control intensity, focus, color, shutter,
image, and form. Pressing any of these will change the
parameters controlled by the encoders.
To view other available encoder pages, simply press the
encoder paging keys to advance the pages.
[Encoder Paging Keys] + [#] will take you directly to a
page. [Flexi] + [Encoder Paging Keys] will toggle the flexi
encoder states.
To post a parameter category to the command line, use the
parameter category buttons.
To post beam to the command line, double press the
shutter, image, or form parameter category buttons.
Some fixtures have more parameters than can be displayed on one
encoder page. The number of. pages for each category is displayed at
the top of the encoder touchscreen. To view the other pages, simply press the encoder paging
button to advance the pages or hold the button and press a number key to go directly to the page
you want to access.
Locking the Encoders
It is possible to lock out the encoders. To lock out the encoders, press [Escape] & [Encoder Page
Keys]. To unlock, press any of the [Encoder Page Keys].
Encoders in Blind
The encoders and level wheel are disabled by default when in the blind display. Pressing an
[Encoder Page Keys], for example [Color], will enable the encoders and level wheel. When the
encoders are disabled, trackball functionality for pan and tilt will also be disabled.
Flexi Encoders
Holding down [Flexi] and an [Encoder Page Keys], for example [Image], will put the encoders into
Flexi mode. In Flexi mode, any empty locations for parameters not applicable for selected channels
will be suppressed.
Encoder Paging Keys
Parameter Category Buttons