ETC Eos Titanium, Eos, and Gio v2.0.0 - Manual (Page 241)

14
Working with a Single Cue List 223
From Summary or Table Views
Use the [Format] key to cycle through the available views.
Summary view allows you to see the greatest number of channels at once, though parameter data
is somewhat truncated. Channels with focus, color, or beam data are indicated with a respective F,
C, or B beneath the level data. This view is useful for viewing lots of channel data at once or for
editing primarily intensity values.
Table view grants you greater visibility of parameter data and a reduced number of visible channels.
This view displays channels along the y axis and parameters along the x axis. Parameter
categories are always visible (I, F, C, and B). You can also view specific parameters by pressing
and holding the [Parameters] button and then pressing the category softkey(s) for the parameters
you wish to view. This will expand the category to show any parameters used in the show. You can
also deselect the parameters you do not wish to see. This is remembered the next time you go to
table view.
The table view is useful for viewing and editing all parameters for a smaller number of channels.
Both summary and table views allow you to make changes to channels/parameters.
From the Cue Spreadsheet
The cue spreadsheet is another useful blind view of cue data. In spreadsheet view, cues are listed
on the y axis and channels/parameters are displayed on the x axis. This view is useful for viewing
a limited number of channels over a span of numerous cues. This is the only view where channel
data of multiple cues can be viewed at once. This makes spreadsheet view useful for viewing
overall trends in channel and parameter data. Pressing [Params] + {parameter tiles} will expand
or collapse information shown.
Editing cue ranges is possible in spreadsheet view. To select an entire cue range, you can press
[Cue] [enter the first cue] [Thru] [Enter].