ETC Eos Titanium, Eos, and Gio v2.0.0 - Manual (Page 404)

386 Eos Titanium, Eos, and Gio Operations Manual
• [Fader Controls] & [Bump Button] - select a fader page on wings.
• [Shift] & [Select] - resets display columns.
• [Shift] & [Up], [Shift] & [Down], [Shift] & Level Wheel - resizes columns.
• [Shift] & [Left], [Shift] & [Right] - moves columns.
Operations
• [At] [Enter] - removes move information from selected channel/parameters. If done in live,
posts the value from the previous cue (numeric) manually. If done in blind, allows the value
from the previous cue to track in.
• [Sneak] [Sneak] - releases NPs of selected channels and self terminates.
• [At] [At] - set to level as defined in setup.
• [Full] [Full] - sets selected channels intensity to full and self terminates.
• [Thru] [Thru] - The [Thru] command accesses only the channels displayed in the current
flexistate (unless the channel range specified is NOT in the current display). [Thru] [Thru]
selects the range regardless of the flexi mode.
• [Undo] - clears an unterminated command line. Otherwise opens the undo controls.
• [Shift] & [Clear] - clears the command line.
• [Copy To] [Copy To] - posts ‘move to’ to the command line.
• [Shift] & [Sneak] - makes manual data “unmanual”. It leaves the values as they are, but they
are then no longer available for update or record only operations. When executed from an
empty command line, this affects all manual data. When done with a channel selection, this
affects only those channels.
• [Shift] & [Full] - flash on.
• [Shift] & [Out] - flash out.
• [Shift] & [+] - +%
• [Shift] & [-] - -%
• [Shift] & [Update] - shortcut to save.
• [Timing Disable] & [Go] - cuts the next cue.
• [Timing Disable] & [Back] - cuts the last cue.
• [Recall From] [Recall From] - posts recall from cue to the command line.
• [Select Last] [Select Last] - repeats last command line, unterminated.
• [Shift] & [Last] - repeats last command line, unterminated.
• [Shift] & [At] - recalls last channel(s) and parameters.
• [Select Active] [Select Active] - select active minus submaster contributions.
• [Shift] & [Select Active] - posts ‘select non-sub active’ on the command line.
• [Shift] & [Select Last] - posts select active to the softkeys.
• [Update] & [Bump Button] - to update a specific submaster.
• [Label] [Label] - appended to a record target command, clears the current label, this includes
show file labels.
• [Shift] & restore manual channel faders - resets faders to zero without asserting control.