ETC Eos Titanium, Eos, and Gio v2.0.0 - Manual (Page 321)

23
Using About 303
{Dimmer Feedback} - appears when the current address is patched to a dimmer in an ETC Sensor
rack with a CEM+ or CEM3. Sensor feedback must be enabled. See
Sensor Feedback, page 373
and Errors and Warnings, page 110 for more information.
{Dimmer Feedback} displays the following information:
• Name (dimmer name)
• Module type
• Rack/Position
• Rack dimmer level (displayed as a percentage)
• Rack dimmer source
• Recorded load
• Actual load
{Dimmer Feedback} displays the following information, which can be modified from Eos by clicking
on the value and entering in a new value:
• Firing Mode
• Control Mode
• Curve
• Threshold
• Scale Minimum
• Scale Maximum
• Preheat Enable
• Preheat Timing
• Advanced Features (AF) Enable
Eos support the following softkey commands from this display:
• {Ignore Errors}
• {Clear Errors}
N o t e : For Sensor feedback, the CEM+ must be running software version 3.0 or later.
N o t e : Clearing CEM+ or CEM3 errors from Eos will be temporary unless the errors have
been fixed at the CEM+ or CEM3. Errors displayed on Eos will clear on their own
once they have been cleared from the CEM+ or CEM3. Some CEM+ or CEM3
errors can only be cleared at the CEM+ or CEM3.