ETC Eos Titanium, Eos, and Gio v2.0.0 - Manual (Page 160)

142 Eos Titanium, Eos, and Gio Operations Manual
Setting Parameters with the Keypad
When the CIA is placed in parameter mode, all parameters of selected channels may be given
numeric values through the keypad.
When no channels are selected, the CIA shows all of the parameters that are available in the
lighting system. When channels are selected, the CIA condenses to show only the parameters that
are appropriate to the selection set. If channels are selected that have different device types, such
as spot and wash lights, the CIA will show all of the available parameters. Parameters that are not
available to all channels are grayed out.
Using [At] [/] [/] will place the direct DMX value on the command line. For example, [1] [At] [/] [/]
[2][3][9] [Enter] would put channel 1 at DMX value 239.
The following examples illustrate how to set parameter values with the keypad:
• [5] {Iris} [5] {Zoom} [6] [5] {Edge} [5] [Enter] - sets channel 5 to an iris value of 50%, a zoom
value of 65%, and an edge value of 50%.
Adjusting Parameters Using + and -
[+] and [-] can be used to adjust parameters from the command line. When using [-], you will need
to preface the command with [+] if you want to remove from the current value.
For Example:
• [Channel List] {Pan} [1][0] - sets to 10 degrees.
• [Channel List] {Pan} [+] [1][0] - adds 10 degrees.
• [Channel List] {Pan} [-] [1][0] - sets to -10 degrees.
• [Channel List] {Pan} [+] [-] [1][0] - removes 10 degrees.
N o t e : Pressing [Shift] + [Encoder Paging Key] will place the associated parameter onto
the command line for numeric entry.