ETC Eos Titanium, Eos, and Gio v2.0.0 - Manual (Page 388)

370 Eos Titanium, Eos, and Gio Operations Manual
found on the drive. Select the file you would like to install and click the {Install} button, or click
{Cancel}. The software will first save to the hard drive before opening the installer.
You will also receive a message if no software update file can be found.
Network Settings
Local Area Connection/ Port 1 and Port 2
These are the settings that determine the method to get an IP address and/or the actual IP address
information that Eos uses for network communication.
Status
This reports if the port is “Online” (configured, connected to a network and operational). It reports as
“Offline” if any one of the above conditions is not true.
Obtain an IP Automatically
Clicking in the enable box will set the desk to get its IP address dynamically from a DHCP server.
While the desk is starting, it will ask for an IP address from a DHCP server. If one responds, it will
use the assigned IP address.
If no DHCP server is available, the desk will default to a self-generated link-local IP address in the
range of 169.254.x.y. The IP address used by the desk in this configuration may change
dynamically as needed. A change should typically only occur when there are changes to the
network configuration or to resolve an IP address conflict.
Enabling or disabling the DHCP setting will require you to reboot the desk for the new setting to take
affect.
N o t e : Eos Ti, Gio, RPU3, and RVI3 have dual NIC. Eos has a single NIC.
N o t e : ETC recommends the use of a static IP address for compatibility with other ETC
devices, though the needs of your particular installation may vary.
N o t e : You cannot set the desk to receive an IP address via DHCP and act as a DHCP
server at the same time. It can either send dynamic addresses or receive them,
but not both at the same time.
Eos Ti & Gio
Eos