ETC Eos Titanium, Eos, and Gio v2.0.0 - Manual (Page 34)

16 Eos Titanium, Eos, and Gio Operations Manual
Dimming Littlites
Desk lamps, such as Littlites, can be dimmed from within the software application.
Desk lamp controls are found in Setup> Desk> Brightness Settings. The {Desk Lamp} slider has
a range of 0% (dimmest) to 100% (brightest). The default setting is 0%. The console will set the
desk lamp to this setting on startup of the application.
See “{Brightness Settings}” on page 131.
The desk lamps can also be controlled by holding down [Displays] and rolling the level wheel.
Cleaning Eos
Should the exterior of your Eos require cleaning, you may gently wipe it with a dampened (not
dripping), non-abrasive paper towel or soft cloth.
If this does not clean the console sufficiently, you may apply some window cleaner (containing
ammonia is fine) to the cloth and repeat the process until clean.
Outputting DMX
In order to output levels from your console, you must connect a Net3 gateway or Net2 node. If your
device receives Net3 or ETCNet2 directly, no gateway or node is required.
Nodes and gateways will function with Eos out of the box without previous configuration. However
if custom configuration is required, you will need to use either NCE (Network Configuration Editor)
or GCE (Gateway Configuration Editor). GCE is installed on Eos by default and can be accessed in
ECU>Settings>Maintenance>Gateway Configuration Editor (GCE). NCE can be installed on
the console or a Windows
®
PC for configuration.
For more information on Net3 gateways or Net2 nodes, see the product literature that accompanied
the hardware or download it from our website at
www.etcconnect.com.