ETC Eos Titanium, Eos, and Gio v2.0.0 User Manual
Page 389
A
Eos Configuration Utility
371
IP Address
If DHCP is disabled, you set the IP address here. This is a static IP address and will remain set
until changed by a user. Eos defaults to an IP address of 10.101.90.101, Eos RPU defaults to
10.101.95.101, RVI defaults to 10.101.85.101, Gio defaults to an IP address of 10.101.91.101 on
port one and 192.168.91.101 on port two, Eos Ti defaults to an IP address of 10.101.92.101 on port
one and 192.168.92.101 on port two, RPU3 defaults to 10.101.93.101 on port one and
192.168.93.101 on port two, and RVI3 defaults to 10.101.86.101 on port one and 192.168.86.101
on port two.
If DHCP is enabled, this field will display the IP address that is being used by the desk (whether it
is served via DHCP or a self-generated link-local IP address).
Subnet Mask
If DHCP is disabled, you set the subnet mask here. This is a static setting and will remain set until
changed by a user. The default subnet mask is 255.255.0.0.
If DHCP is enabled, this field will display the subnet mask that is being used by the desk (whether
it is served via DHCP or a self-generated link-local IP address).
Gateway
If DHCP is disabled, you set the gateway IP address here. This is a static gateway IP address and
will remain set until changed by a user. The default gateway on Eos is 10.101.90.101, Eos RPU
defaults to 10.101.95.101, and RVI defaults to 10.101.85.101.
If DHCP is enabled, this field will display the gateway IP address that is being used by the desk
(whether it is served via DHCP or a self-generated link-local IP address).
Physical Address
The physical address is the MAC address. This address is a unique identifier and cannot be
modified.
Enable Remote Startup/ Shutdown
It is possible to remotely power on and off some devices, such as RVIs, RPUs, and client desks.
{Remote Startup} and {Remote Shutdown} must be enabled on each device before it can receive
the power on and off commands. The default setting for both is Disabled.
The Remote Power commands are sent from the browser. The command for Power On is sent from
Browser>Network>Power On MultiConsole System, and the command for Power Off is from
Browser>Network>Power Off MultiConsole System.
N o t e :
Eos desks cannot be remotely powered on.
N o t e :
Only devices that synchronize with the Primary will be available for Remote Power
On and Off.