ETC Eos Titanium, Eos, and Gio v2.0.0 - Manual (Page 320)

302 Eos Titanium, Eos, and Gio Operations Manual
About Address
Press [About] to put the CIA into “About” mode. When an address is selected, the information
below is displayed. You can select the information you wish to view from the buttons located on the
right side of the CIA. Additional buttons may display based on RDM and Sensor Feedback if
enabled. The buttons are:
{Address} displays the following information:
• Address number (displayed as straight address and port/offset)
• Dimmer label (if any)
• Associated channel number, which is a hyperlink to the [About] channel display.
• Part number (if any)
• Notes
• Output value (ACN, Net2, ArtNet, Avab UDP, or DMX)
• Current output value and source of output
• Parameter controlled by the address
• Home Value
• Basic patch information
• Extended patch information (if available)
• If it is a scroller, color/gobo wheel, the assigned scroll or wheel is indicated
{Next Part} & {Last Part} will advance to the next part or go back to the previous part. These
buttons only display for addresses with parts.
{Go To Patch} is a shortcut to edit the patch for the address selected. This will open up the patch
display.
{Library Data} displays the following information:
• Revision number
• Release date
• Open issues list (if available)
• Usage notes including switch settings and configuration (if available)
• Alternate fixture names (if any)
{Lamp Controls} displays controls for the lamp or other parameters of the device (if it is a moving
light).
{Address Check} will bring current address to full.
{Next/Last Unpatched} will allow you to see what addresses closest to the current address are
currently unpatched.