Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector - Manual (Page 106)

106 Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012
Chapter 3 Loading and Unloading
Loading Lists to the Data
Collector After you connect the data collector to the computer, you can load one or more
lists to the data collector. This section discusses preparing and initializing the
data collector, loading inspection codes, selecting the list, and other load options.
Preparing the Data Collector before Loading
Emonitor can load data to either the Enpac internal memory, or to a memory
card. You control the destination for the data with the Route Mem parameter in
the Setup screen in the Enpac 2500.
1. Make sure you have correctly connected the data collector to the computer.
Refer to Connecting the Data Collector and Computer (RS-232) on page
102
.
2. Power up the data collector.
3. If you are going to load data to a memory card, insert the card into the
PCMCIA slot in the bottom of the Enpac.
4. From the Main Menu screen, select Setup Utility and press the READ/
OK key. The Setup screen appears.
5. Highlight Route Mem and press the RIGHT ARROW key to display the
following choices:
• Internal
- Load the data to the Enpac internal memory.
• Storage Card - Load the data to the memory card in the Enpac.
• SD Card - Load the data to the SD memory card in the Enpac.
6. Select the destination and press the LEFT ARROW key to save your
choice.
7. When finished, press F4 (Apply).
IMPORTANT When loading large lists to the Enpac 2500, recommended practice is to
connect the power supply to the Enpac 2500. This disables the automatic
timeout feature (Instrument Setup) which could cause potential loss of
data during the loading process.