Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector - Manual (Page 41)

Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012 41
The Enpac 2500 Data Collector Chapter 1
Table 7 - Setup Screen Parameter Descriptions
Parameter Description Value
Route Mem Sets the location where the loaded route data is stored. Internal (default)
Storage Card
Timeout The number of minutes the Enpac 2500 can remain idle before it shuts itself off to
conserve battery power.
Press On/Off to reactivate the instrument following a timeout. The instrument returns to
the point in the program where it was when it shut off. No stored data will be lost.
Off (default)
5 min
10 min
15 min
20 min
Trigger Sets the Phase/Order input trigger synchronization:
• Laser Tach enables the internal Laser Tachometer when a Phase or Order
measurement is collected.
• External uses the trigger input from the POWER/USB/TRIGGER connector as the
trigger source.
• RS-232 transfers data can also be transferred between the data collector and your
computer.
External (default)
Laser Tach
RS-232
Dflt Units Defines the units of measurement for Offroute standard velocity measurements.
Important: Used only* for Offroute standard velocity measurements.
English (ips) (default)
Metric (mm/s)
Date Format The format of the date displayed in the Enpac 2500. MM/DD/YYYY (default)
DD/MM/YYYY
YYYY/MM/DD
Time Zone Sets the time zone.
Only used when using ActiveSync software data synchronization. The time zone on the
instrument must match the time zone on the computer. If you are not using ActiveSync
software then the time zone setting has no effect.
Important: Always set your instrument to the correct time zone or your files will not be
in sync by time zone.
List of 30 time zones
Date/Time Displays the date and time in the format you select in the Date and Time parameters. Current data and time
Memory Configures the memory:
• Select cmd to exit this field without selecting an option.
• Delete all routes and data from memory.
• Initialize formats the memory. Deletes all files from memory including any route files
and directories.
Important: These commands are performed on the memory location as set by Route
Memory.
Select cmd (default)
Delete all routes
Initialize
Route Font You can select the font size for the Route. Big or Small
Envelope The type of envelope to use for high frequency and rolling element bearing analysis.
Determines which pre-defined measurement you can use to collect Offroute data.
gSE (default), collects an Offroute gSE point.
ESP, collects an Offroute ESP point
Navigation Determines how the instrument navigates through the routes in the Data Collection
screens when the Right arrow key is pressed:
• Enpac- The instrument displays a Selection screen from which you select the item
you want to collect or review.
• DataPac - The instrument functions like a dataPAC 1500 in that it automatically
advances to the next point in the route.
Enpac
DataPac (default)
Transducer Change Notification of a transducer change.
If set to Warn, a prompt appears on the screen warning you of the transducer change.
Warn (default)
Do not warn