Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector - Manual (Page 116)

116 Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012
Chapter 3 Loading and Unloading
If Emonitor can match the unscheduled data to an item in the Hierarchy Tree
and a location, then it stores the unscheduled data in measurement definitions
under that location. If Emonitor cannot match the data with an existing
measurement definition, then it creates a new measurement definition and stores
the data there.
If Emonitor cannot match an item in the Hierarchy Tree and a location, it stores
the data in the unscheduled destination, set with Tools > Set Unscheduled Dest.
Emonitor tries to match the collection specification for the measurement
definition. The rules for matching a collection specification are as follows.
If Emonitor cannot match the collection specification, it creates a new collection
specification using a code. The new collection specification name has the form
XXXXLMSWNNEp, where:
The parameters of the fields in the collection specification name are explained in
the Emonitor online help.
Table 32 - Rules for Matching a Collection Specification
All types Magnitude Spectrum Time Waveform
All these measurement
parameters in the collection
specification must match: Transducer
Averaging type
Number of Averages
Percent Overlap
Order Normalization Transducer
Averaging type
Number of Averages
Percent Overlap
Order Normalization
Fmax (or Frequency Span)
Number of lines Transducer
Averaging type
Number of Averages
Percent Overlap
Order Normalization
Fmax (or Frequency Span)
Number of lines
Signal detection Transducer
Averaging type
Number of Averages
Percent Overlap
Order Normalization
Signal detection
XXXX maximum frequency
L number of lines
M transducer type
S signal detection
W window type
NN number of averages
E average type
p phase measurement flag