Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector - Manual (Page 21)

Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012 21
The Enpac 2500 Data Collector Chapter 1
Parts of the Enpac This section describes the basic components of the Enpac 2500 including key
definitions, hardware connections and status indicators. If you are already
familiar with the components of the data collector, you may want to skip this
section.
Enpac 2500 Diagram and Key Definitions
This is a diagram of the Enpac 2500 data collector showing the keys used for
operation.
Figure 1 - Diagram of the Enpac 2500
READ/OK Key
Arrow Keys
ON/OFF
Numeric Keys
+/- Decimal 0 or Shift
READ/OK Key
Function Keys
(F1 to F4)
Table 2 - Key Definitions
Keys Definition
Read/OK The READ/OK key starts collecting data for the current point or accepts the current
measurement. There are two keys so you can use the data collector with either your left or
right hand.
Function Keys Below the display are four function keys referred throughout this manual as F1, F2, F3,
and F4. The function keys change depending on the current state of the data collector. The
data collector displays the current function of the keys in the display above the key. When
no text appears above a function key, the key is inactive in the current window.
Up Arrow • Moves to the previous field or menu selection.
• Decreases the Y-axis scaling in a signature plot.
Down Arrow • Moves to the next field or menu selection.
• Increases the Y-axis scaling in a signature plot.
Left Arrow • Displays the previous screen of information if there is more than one screen (for
example, selecting a point in the Data Collection screen).
• Closes the menu selection on the Setup and Instrument Configuration screens.
• Moves the signature cursor to the left.