Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector - Manual (Page 123)

Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012 123
Collecting and Reviewing Data Chapter 4
Follow these steps to move to another a measurement or machine.
1. Select the desired hierarchy level (Plant, Train, Machine, and Location).
2. Press the Right arrow key.
A selection screen appears. A checkmark next to the item indicates that a
measurement has been stored.
3. Select an item and press the Left arrow.
4. Continue collecting data and move through the list until you reach the end
of the list.
TIP The Selection screen does not appear if you set Navigation to
DataPac in the Setup screen. The Enpac 2500 data collector
automatically moves to the next point in the route when the Right
arrow key is pressed.