Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector - Manual (Page 26)

26 Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012
Chapter 1 The Enpac 2500 Data Collector
Strap Attachment
The strap can be fitted to either the left or right side of the Enpac 2500.
1. Feed the ends of the strap through the top and bottom corner pillars as
shown in the illustration below.
2. Loop the ends of the strap through the buckles and adjust the tightness to
suit.
Battery Pack The Enpac 2500 data collector can be powered either from its own internal
Lithium Ion battery or by connecting the DC output of the mains power supply
to the in line socket of the USB Power Splitter cable. Then connect the Fischer
plug into the Power socket on top of the Enpac. The Enpac also has an internal
backup battery which maintains the system settings should the battery become
discharged or removed while the unit is not being powered by an external DC
supply.
This section describes how to check the battery level information and remove the
battery pack from the data collector. The Enpac battery pack is located on the
underside of the Enpac.