Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector - Manual (Page 270)

270 Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012
Chapter 10 Run Up/Coast Down Application
Displaying the Table
When you are done setting up the table parameters, you can process the data and
display the table by pressing F4 (Display) on the RUCD - Table Setup screen.
Up to two orders of the magnitude and phase data set is displayed in the table. To
scroll through the table, press the UP and DOWN ARROW keys.
You can also display the data in a Bode plot or Nyquist plot. To display the data in
a Bode plot, press the 0 (Shift) key and F4 (Bode) simultaneously.
Refer to Displaying the Bode Plot on page 264 .
To display the data in a Nyquist plot, press the 0 (Shift) key and F1 (Nyquist)
simultaneously.
Refer to Displaying the Nyquist Plot on page 267 .