Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector - Manual (Page 38)

38 Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012
Chapter 1 The Enpac 2500 Data Collector
Figure 6 - Engineer Mode Menu Screen
The Engineer Mode Menu provides you the following options. To select one of
the options, press the respective numeric key.
1. Force Clean Boot - During a normal boot sequence, the unit will
automatically update the registry contents into Flash memory so that any
changes are permanently stored. Select this option to bypass the normal
boot sequence and revert back to a ‘clean or default setup.
2. Download Image from Serial - Select this option to install a new
operating system onto the unit over the RS-232 serial interface. The
WinSerDL utility is required with this option.
Refer to Operating System Update Procedures on page 50 .
3. Download Image from PCMCIA - Select this option to install a new
operating system onto the unit using a PCMCIA ATA Flash card (FAT
format).
4. Touch Recalibration - This option is not supported in the Enpac 2500.
5. Exit and Launch CE - Select this option to exit the Engineer Mode Menu
and launch the Windows CE operating system.
Option 4 is not supported in the Enpac 2500.