Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector - Manual (Page 187)

Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012 187
Multi-channel Measurements Chapter 6
7. Press Enter to start taking the measurement.
8. Point the data collector.
Notice that the Laser Tach is operational.
9. When the measurement stabilizes, press Enter to store the reading.
TIP You press F1 (Config) on the Route Manager screen to set the trigger. You can
also set the trigger on the Instrument Configuration screen by pressing 0 on
the Data Collection screen:
• Set the trigger to Laser Tach if using the internal trigger.
• Set the trigger to External if using a external trigger device.
ATTENTION: When the laser on the data collector is active, viewing the laser
beam can expose your eyes beyond the maximum permissible exposure
recommendations and cause harm.