Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector - Manual (Page 126)

126 Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012
Chapter 4 Collecting and Reviewing Data
Select Inspection Codes
Inspection codes let you document operating conditions while collecting data.
You must load the inspection codes into the Enpac 2500 data collector when you
load a list. Only those inspection codes loaded with a list are available for that list.
Using the Emonitor software, you can load up to 100 inspection codes per list.
The data collector lets you to store up to six inspection codes with each
measurement point. The Emonitor software automatically unloads the
inspection codes from the data collector when you unload the data.
Follow these steps to enter an inspection code while you collect data.
1. Press F3 (Notes) while in any measurement screen.
The Notes screen appears.
2. Select a code by entering the inspection code number and press Enter.
A checkmark appears to the left of the assigned inspection code:
• To clear the checkmark, highlight the inspection code and press Enter
again.
• To save your changes and return to the measurement screen, press F2
(OK).
• To cancel your changes and return to the measurement screen, press F3
(Cancel).
TIP If you notice an unusual condition prior to data collection, such as bad belts,
you can select an inspection code that applies to the current point on the route.