Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector - Manual (Page 280)

280 Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012
Chapter 10 Run Up/Coast Down Application
You can save the RUCD setup and measurement anytime the Save function is
displayed on the screen.
1. Press F3 (Save) if you are saving the data from the Setup screen. Press F4
(Save) if you are saving the recorded data from a plot screen.
The RUCD - Save Data screen appears.
2. Do one of the following:
•
To save the data to an existing file, highlight the file, and press F4
(Save). Press F2 (Yes) to overwrite the existing file. Note that you can
return to the Save screen without overwriting the file by pressing F3
(No).
• To save the data to a new file, highlight ‘save reading as‘ and press F4
(Save). Enter a file name using the keypad or accept the default file
name (current date timestamp). When the entry is complete, press F4
(OK).
3. When you are finished, press F1 (Cancel).
IMPORTANT The setup parameters are saved along with the measurement when you
press F4 (Save) on the RUCD - Save Data screen.