Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector - Manual (Page 98)

98 Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012
Chapter 3 Loading and Unloading
Figure 21 - Load/Unload Dialog Box
Set Up the Current Data Collector in Emonitor
You can have several active data collectors in Emonitor. However, you must select
one specific data collector before you load a list. The data collector you select is
called the current data collector. If you use several different models of data
collectors, you may need to select the current data collector before unloading and
loading. If you use only one model of data collector, you can select the current
data collector only once and not change it again.
An icon of the Enpac 2500 appears in the Set Up Collector button in the Load/
Unload dialog if it is the current data collector. If not, follow these steps to make
the Enpac 2500 the current data collector and select the correct communication
settings.
1. Choose Tools > Load/Unload. The Load/Unload dialog appears.
2. Click the large Set Up Collector button in the Load/Unload dialog. The
Set Up Data Collectors dialog appears.
Click to set
computer
communication
options.
Click to set data
collector
communication
options.