Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector - Manual (Page 28)

28 Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012
Chapter 1 The Enpac 2500 Data Collector
This table shows battery status icons relative strength of the battery.
Inserting and Removing the Battery Pack
1. Using a flat head screwdriver, remove the quick release screws (underside
of the data collector).
2. Remove the battery cover.
3. Slide the cell to the left and lift it out from the data collector.
The battery is inserted into the data collector by following this process in
reverse order.
Table 6 - Battery status icons
Battery Icon Meaning
Battery status is good (>30% life remaining)
Battery status is low (>10% life remaining)
Battery status is very low (<10% life remaining)
Battery charging
IMPORTANT The Enpac 2500 will automatically notify you when the battery status is
30% or lower. To clear the notification, press the Decimal (.) key. The
notification will periodically appear until the battery is recharged or the
power adapter is attached.
When the battery status is 10% or lower, communications is prohibited.
TIP The Enpac has a safety switch positioned under the plate of the
battery compartment. When you remove this cover, the data
collector shuts down (as if the ON/OFF key was pressed.)
Release screws to access battery
pack.
Once battery cover is removed,
slide cell to left and lift out.