Preface, Using the manual, Upgrade options – Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector User Manual
Page 13: Using the manual upgrade options
Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012
13
Preface
The content in this manual is based on the following firmware revision and
software version.
•
Enpac® 2500 data collector, firmware revision 3.10
•
Emonitor® software, version 3.4
Using the Manual
This manual covers the Enpac 2500 data collector module which is used for
predictive maintenance using noise and vibration analysis. It describes also how
to use the Emonitor software to load and unload lists.
When using the Enpac 2500 data collector, you can do the following:
•
Create lists of measurement definitions.
•
Load lists from Emonitor into the data collector.
•
Use a 40 Khz fmax, Route and Offroute.
•
Collect magnitude, process, spectrum, time, and phase data.
•
View selected alarms.
•
Select inspection codes to store with a measurement.
•
Define and collect unscheduled measurements
•
Unload the data from the data collector directly into the Emonitor
database.
•
View the high resolution, up to 12,800 lines on the data collector.
Upgrade Options
These are the upgrade options for the Enpac 2500 data collector:
•
1441-PEN25-MOD-2CH 2 - Channel Upgrade Kit
Two Channel application allows for advanced use of orbits, cross channel
phase, and simultaneous data collection in route and off route collection.
•
1441-PEN25-MOD-BMP - Bump Test
A bump test (or hammer test) determines the natural frequencies of a
machine or a structure.
•
1441-PEN25-KIT-BAL - Balancing
Balancing application resolves single-plane, two-plane, and static-couple
balances with high precision.
•
1441-PEN25-MFRF - Frequency Response Function
The FRF test lets you determine the natural frequencies of a machine as
well as sophisticated information about the frequency response of the
structure being tested.
•
1441-PEN25-MOD-REC - Time Recorder
The Time Recorder test uses a the instrument as a data recorder for real-
time data acquisition and analysis.
•
1441-PEN25-MOD-RUCD - Run Up Coast Down
The RUCD test records and analyzes data from intermittent events and
transient vibration signals from non-steady state machines.