Metrohm 711 Liquino - Manual (Page 22)

2.5 Connections
711 Liquino, Instructions for use 16
2.5.2 Serial connections
A wide range of possible connections can be made at the RS232 interface.
As well as all Metrohm instruments which are equipped with the Metrohm
remote control language, a printer (requirement: serial interface or paral-
lel/serial converter) or a personal computer (PC) can also be connected.
Any instrument from another manufacturer which is equipped with a serial
RS232 interface can also be connected.
A requirement for correct data transmission is that the transmission parame-
ters are correctly set; these must coincide with the interface settings of the
connected instrument (see following page).
Control commands (examples):
>SEQ sequence st ep 4 (Control command)
st r i ng &M; $G starts Metrohm instrument
>SEQ sequence st ep 6 (Control command)
st r i ng &M; $S stops Metrohm instrument
Input data query (example):
>SEQ sequence st ep 5 (Scan command)
st r i ng * R" wait for ready message from
Metrohm instrument
The following section provides information about the settings and cables
necessary to connect a printer.
cable 6.2134.040 (9-pin/9-pin)
or 6.2134.050 (9-pin/25-pin)
printer cables: see page 17f
711