Metrohm 711 Liquino - Manual (Page 61)

3 Introduction
711 Liquino, Instructions for use 55
<SELECT>
<ENTER>
<SELECT>
<ENTER>
2x <QUIT>
command: NO OPERATI ON
• "4. Pause for 1 minute.“
Proceed as in step 2: select the command ‘Pause’ and enter
’00:01:00’. Press <ENTER> to accept the entry.
Di spl ay: >SEQ sequence st ep 5
command: NO OPERATI ON
• "5. Temperature-controlled azo coupling (temperature below approx. 10
°C).“
Select the command ‘METHOD’ and then the XDOS method which has
been created and stored for the azo coupling. Confirm each step with
<ENTER>.
Di spl ay: >SEQ sequence st ep 6
command: NO OPERATI ON
• All the necessary entries have now been made. Press the <QUIT> key
2x to exit the parameter menu. The instrument is now in its normal
state.
When working on a sequence it is possible to switch rapidly between
steps which have already been entered or to insert or delete a step with
the aid of the following keys (provided that the program is in the command
selection of a step, e.g.
command: PAUSE ):
<> and <> change to the next and previous command respectively.
<HOME> and <END> go to the first and last command respectively.
<INSERT> shifts the current and all subsequent steps downwards by one
position and inserts a ‘NO OPERATION’ command.
<DELETE> deletes the current step and shifts all subsequent steps up-
wards by one position.