Metrohm 711 Liquino User Manual
Page 94
4.5 SEQ mode - complex processes
711 Liquino, Instructions for use
88
These status messages are only transmitted if first the corre-
sponding status message has been switched on, e.g. for a Titrino
with the command:
command: CONTROL
i nt er f ace: RS
st r i ng: &Se. A. T. R"ON"
Details about the Metrohm remote control language can be found
in the ‘Instructions for use’ of the corresponding instrument.
It is essential that the transmission parameters of the RS232 inter-
faces of both instruments are in agreement. Use RS cable
6.2125.010 for the connection.
•
ENDSEQ — this command is used for marking the end within a se-
quence. It can be inserted into any command line for test purposes. This
always has the effect that the sequence is only processed up to this line.
However, it is not essential that a sequence has an end marking.
SEQ as method
A process sequence can, like the other instrument modes, be stored as a
method. Sub-methods must be defined and stored before a sequence is
put together.
Before carrying out a SEQ method make sure that all the sub-methods re-
quired are available, i.e. that they have not been deleted.