Metrohm 711 Liquino - Manual (Page 35)

3 Introduction
711 Liquino, Instructions for use 29
3.2.5 Temperature measurement
The 711 Liquino is equipped with a Pt100 temperature measuring input.
Apart from temperature-controlled dosing this means that simple manual tem-
perature measurements can also be carried out.
MANUAL
MAN OFF
D
TEMP
9
I
MANUAL
MAN OFF
D
• Connect a Pt100 temperature sensor. The connection socket is on the
rear panel of the 711 Liquino. Use the <MANUAL> key to switch to
manual operation. Then press <TEMP>.
Di spl ay: manual
21. 5° C
• The measured temperature in degrees Celsius is shown immediately. The
measurement can be switched off by pressing the <MANUAL> key again.