Metrohm 711 Liquino User Manual
Page 38
3.2 Tutorial
711 Liquino, Instructions for use
32
START
Z
<ENTER>
•
From now on when <START> is pressed the method will be run im-
mediately.
•
The pipetting process consists of several steps. For each step instruc-
tions are shown on the display. If the pipetting attachment is used then
the key built into the handle can be used to switch from one step to the
next. The pipetting process can also be started with it. Whenever the
LED on the handle lights up the 711 Liquino is ready for the next step.
Without the pipetting attachment <ENTER> must be pressed in order
to carry out the next step.
•
In the first step a separatory bubble is formed, which is located be-
tween the "hydraulic“ liquid (in this case water) and the sample. Just
follow the instructions shown on the display.
*) The warning about the preparation of the tubing system appears each time the mode is changed and after
the instrument has been switched off and on again. If it is certain that the Dosinos used have already been
prepared then press <NO> (<QUIT> key) to acknowledge the warning. The method can now be run in the
normal manner by pressing <START>.