Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 101)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
5-5
5.4 Installing and removing the fan
5 Installation
5.4 Installing and removing the fan 5400 Installing and removing the fan 5- Montage_Luefter
The fan does not require wiring. Connectors built into the fan housing
plug into sockets underneath the servo amplifier.
Installation and removal: Fan on servo amplifiers with 70 mm width
Removal
Gently compress the fan housing lengthwise.
Pull the fan housing downwards.
Installation
Position the fan so that the green connector is
aligned with the socket on the PMCprotego D.
Push the fan on to the connector until the fan
housing clicks into place. Gently compress the
fan housing lengthwise.
Installation and removal: Fan on servo amplifiers with 100 mm width
Removal
Gently compress the fan housing crosswise.
Pull the fan housing downwards.
Installation
Position the fan so that the green connector is
aligned with the socket on the PMCprotego D.
Push the fan on to the connector until the fan
housing clicks into place. Gently compress the
fan housing crosswise.