Standards, 3safety, 3 standards – Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC User Manual
Page 28
3.3
Standards
3
Safety
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
3-6
3.3
Standards
3300
Standards
3-
][Sicherheit_Normen
Servo amplifiers are components designed for incorporation into electri-
cal plant or machinery within the industrial sector. The servo amplifier
may not be used for its intended purpose until it has been established
that the plant or machinery complies with the provisions of the following
directives:
`
EU Machinery Directive (2006/42/EC)
`
EU EMC Directive (2004/108/EC)
`
EU Low Voltage Directive (2006/95/EC)
Standards for compliance with the EU Machinery Directive (2006/
42/EC)
`
EN 60204-1:2007 (Safety and electrical equipment of machines)
`
EN 12100:2009 (Safety of machinery)
The machine manufacturer must produce a hazard analysis for the ma-
chine and take appropriate measures to ensure that unexpected move-
ments do not cause injury to people or damage to equipment.
Standards for compliance with the EU Low Voltage Directive (2006/
95/EC)
`
EN 60204-1:2007 (Safety and electrical equipment of machines)
`
EN 60439-1:2005 (Low voltage switchgear and controlgear assem-
blies)
`
EN 61800-5-1:2007 (Adjustable speed electrical power drive systems
- Safety requirements)
Standards for compliance with the EU EMC Directive (2004/108/EC)
`
EN 61000-6-1/2:2006 (Immunity for residential, commercial and light-
industrial environments)
`
EN 61000-6-3/4:2007 (Emission standard for residential, commercial
and light-industrial environments)
`
EN 61800-3:2004 (Adjustable speed electrical power drive systems -
EMC requirements)
It is the manufacturer's responsibility to comply with the limit values for
the plant or machinery as required by EMC legislation. This documenta-
tion contains tips on how to make your installation EMC-compliant (such
as shielding, earthing, how to manage the connectors and lay the ca-
bles).
UL conformity
`
UL 508C
UL 508C describes the fulfilment by design of minimum requirements
for electrically operated power conversion equipment, such as fre-