3 ethernet interface (in development), 9 sd card, 4function description – Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC User Manual
Page 70: 3 control element
4.3
Control element
4
Function Description
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
4-38
4.3.8.3
Ethernet interface (in development)
Ethernet interface (in development)
4-
][Funktion_Ethernet_protego_D
The servo amplifier operates as an Ethernet subscriber. The connection
to Ethernet is made via the two 8-pin RJ45 sockets.
Communication is possible via the following network protocols:
`
SafetyNET p RTFL (in development)
`
Other protocols on request
Various operating and fault statuses are displayed via the LEDs on the
two RJ45 interfaces.
4.3.9
SD card
SD card
4-
][Funktion_MMC_protego_D
The top of the servo amplifier contains a card reader for an SD card.. The
memory card is used to download the firmware and parameter sets to
the servo amplifier.
Using the SD card you can quickly and easily commission an exchange
unit or identical axes on series machines.
RJ45
LED
Name
Signal
Meaning
LED1
LINK_IN
On
Receipt is valid (IN port)
Off
Invalid, power off or reset
LED2
CYCLIC
On
Network cyclical
Flashes
Network not cyclical
Off
Power off or reset
LED3
LINK_OUT
On
Receipt is valid (OUT port)
Off
Invalid, power off or reset
LED4
REPEATER
On
Repeater on, network cyclical
Flashes
Repeater on, network not cyclical
Off
Repeater off, power off or reset
DANGER!
Only insert or remove the memory card when the servo amplifier
is switched off.
Carry out a reference run if you are using an absolute encoder or
have read in new parameters.
LED1
LED4
LED3
LED2