Safety during operation, 3safety, 2 safety during operation – Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC User Manual
Page 27
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
3-5
3.2
Safety during operation
3
Safety
3.2
Safety during operation
3200
Safety during operation
3-
][Sicherheit_Bestimmung_Betrieb_1
While the units are in operation there is a risk of death or serious injury
and material damage.
`
Do not open or touch the units during operation.
`
Keep all covers and cabinet doors closed during operation.
`
When the units are switched on, they should only be touched during
commissioning by qualified staff.
`
During operation the servo amplifiers may contain live, uninsulated
components, depending on their protection type.
`
Control and power connections may still carry voltage, even when the
motor is not rotating.
`
Surfaces on the servo amplifiers may become hot during operation.
Temperatures may reach more than 80° C.
][Sicherheit_Bestimmung_Betrieb_2
In unfavourable conditions arcing may occur, causing potential injury to
persons and damage to electrical contacts.
`
For this reason, never unplug the electrical connections on the servo
amplifier while voltage is applied.
`
After disconnecting the servo amplifier from the mains voltages, wait
at least eight minutes before touching any parts that carry voltage
(e.g. contacts) or loosening the connections.
`
After the mains voltages have been switched off, capacitors continue
to carry hazardous voltages for up to 8 min. (5 min. for 1.5 to 12 A
types, 8 min. for 24 A types).
`
To be safe, measure the voltage in the intermediate circuit and wait
until the voltage has dropped below 40 VDC.
DANGER!
DANGER!