Installing the servo amplifier, 5installation, 3 installing the servo amplifier – Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC User Manual
Page 99
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
5-3
5.3
Installing the servo amplifier
5
Installation
5.3
Installing the servo amplifier
5300
Installing the servo amplifier
5-
Montage_protego_D
`
Materials: 3 hexagon socket cylinder head screws DIN 912, M5
`
Required tool: Hexagonal wrench 4 mm
Proceed as follows:
`
Drill M5 holes in the control cabinet's mounting plate, as shown in the
illustrations.
`
Remove the fan underneath the servo amplifier (see section in this
chapter entitled: “Installing and removing the fan”).
`
Attach the servo amplifier to the mounting plate in your control cabi-
net,
`
Replace the fan underneath the servo amplifier.
INFORMATION
Remove the fan before installing the servo amplifier.
Replace the fan once the unit is installed. See section entitled:
“Installing and removing the fan”.