MacroSystem Bogart SE Ver.4 User manual - Manual (Page 108)

108 Appendix
both display and power saving to ‘immediately’, the Casablan-
ca will go into standby mode right away when it is switched
off . Please note that some units may not have a 0-Watt
standby operation . This also only works after a device has
been connected to the power line for at least a day . In 0-Watt
use, the display does not show the time . In addition, you can
also open the “noise management” window . This is where you
change the setting for the ‘DVD/Blu-ray unit’ in order to reduce
the noise produced by the system . is filled out . However, the image is not simply cut off at the
sides, it remains fully visible . For this purpose, the sides are
‘squeezed’ to fit . The middle section of the image remains
unchanged . Only very busy scenes or scenes with frequent
camera pans may pose a slight problem with distorted image
portions on the side . You can avoid this by choosing a differ-
ent mode .
Cinema mode:
This has an influence on the DVI/HDMi output, not on the
SCART/AV connection . Depending on whether the movie was
originally made for television or cinema, the HD signal needs
different processing to obtain a better image quality . For televi-
sion productions, the switch should be “off”, for cinema pro-
ductions it should be “on” . There is also an “automatic” option .
This way, you don’t have to switch all the time . The device
then tries to find the best mode by itself, automatically . Please
not that the necessary information is not always transmitted
properly by the broadcaster . This may sometimes cause the
automatic function to choose the wrong mode . In such cases,
you have no choice but to switch to the correct mode yourself .
Should you not be certain, and experience somewhat annoy-
ing artefacts (particularly with television productions for which
the cinema mode has been erroneously activated), you should
switch this option to “off” .
3.3.2 Language, delay
Use these settings for movies with several sound channels .
Select your preferred language in item 1 . This will be used au-
tomatically for multi-sound-channel movies . You can also set a
desired delay between sound and image, in milliseconds . This
function is useful in case your television needs more time to
construct its images than a surround amplifier . You should test
several values, in case videos are not synchronous .
3.4 Connections
Depending on the device used, this is where you decide on
the format for the top SCART connection (TV) . Activate either
CVBS + RGB or YC . You can also set up the bottom SCART
(Video) connection (CVBS + RGB or YC) . Make sure to choose
the right setting to avoid a bad or monochrome image . If you
can’t see the picture or if the image is shown incorrectly, the
system will return to the previous mode after 10 seconds .
3.5 Device
Here, you can set up the ‘Power Saving’ mode and decide if
and when it should be activated . If your deactivate it complete-
ly (‘Never’), the device is not powered down completely when
you switch it off, but the menus become black . This has the
advantage that the unit starts up faster . You can also change
the settings for the display that is built into the device . You
can set up the display brightness modes for standby or in use
and if or when the display should be switched off . If you set up