MacroSystem Bogart SE Ver.4 User manual - Manual (Page 87)

87 Bogart SE 4 User manual
TURNING OFF
Problem: The machine won‘t turn all the way off, the red light
remains lit .
Solution: The machine is in stand-by mode meaning that the
red light is always on . This mode of operation saves electricity
if you use the machine often . If you don‘t plan on using your
system for an extended period of time, then you should pull
the power plug (after having turned off the machine) .
Problem: Is data lost if I pull the power plug for an extended
period of time?
Solution: No, your data is stored on the internal hard drive .
However, before pulling the plug you should power-down
the machine correctly by pressing the power switch on the
front of the machine or by clicking on the “OFF“ button in the
Main Menu screen . This also applies to all other cables . Never
disconnect a cable from your system while the machine is
operating .
Problem: The machine does not turn off right away . It takes a
while .
Solution: This is normal behavior for your system . Before the
machine is actually turned off the current project is automati-
cally saved . This can take several seconds . The machine will
only turn itself off when the project has been saved success-
fully . However, if the shutdown program receives no message
from the machine, it will turn the machine off, but only after
several seconds .
Problem: I have a problem, not contained in this list .
Solution: If you have access to the Internet, check out the fol-
lowing web site: http://www .macrosystem .de . Here (“Support“,
“FAQ“) you will find an updated list of FAQs (Frequently Asked
Questions) that may help you . You can also call your dealer, or
call our hotline if you have technical questions .