RLE FMS V.1.13 - Manual (Page 37)

rletech.com FMS User Guide 37
2 Getting Started
4 Select the Configuration Menu link, then select the System link. Select the IP
Configuration Menu link and change the IP address, Subnet Mask, and default Gateway to
one provided by the network administrator. Press the Submit Changes button. The FMS
will save the new IP address and reboot. Once the FMS reboots, the system status LED
stops flashing. Use the new IP address and reset the computer to its original IP address and
Subnet Mask.
5 Change the IP address of the computer back to its original IP address. If the computer was
configured as DHCP (the network domain controller assigns an IP address) return it to this
state. This may require assistance from your IT Department, or consult the computer’s
manual.
6 The computer and the FMS are now both configured to communicate on the network. Both
should be accessible via the network. Connect the PC and the FMS to the network. From
the PC Web browser, type in the IP address of the FMS. Enter the user name and password
as stated above to verify network access to the FMS.
2.3.4 Set the FMS IP Address using an EIA-232 Connection
To use the EIA-232 interface:
1 Connect the EIA-232 port (P3 - Com2) on the FMS to a terminal or PC running terminal
emulation software (HyperTerminal) with a 9-pin male-female straight through serial cable.
2 Set the appropriate communication port to 9600 baud, NO parity, 8 data bits, 1 stop bit,
(9600/N/8/1), and no software or hardware flow command.
3 Once the terminal emulation software starts, press Enter on the keyboard and the FCF>
should appear. If the FCF> does not appear, check the communication settings and make
sure the unit is powered on.
4 IP Address: From the FCF> type “IP” then press <enter> to view the current IP address.
To change the IP address, type IP, <space> and the new address to be assigned, then press
the enter key, example: IP 192.168.1.225 <enter>.
5 Subnet Mask: From the FCF> type “NM” then <enter> to view the current Netmask
address. To change the Netmask address, type NM, <space> and the new address to be
assigned, then press the enter key, example: NM 255.255.255.243 <enter>.
6 Default Gateway: From the FCF> type “DG” then press <enter> to view the current
Default Gateway address. To change the Default Gateway address, type DG, <space> and
the new address to be assigned, then press the enter key, example: DG 192.168.1.1 <enter>.
7 Every time you make a change the Falcon FMS will automatically save the changes.
See Chapter 5, “EIA-232 Interface” on page 161 , for more information on the EIA-232
command set.