Super Systems 9130 Series - Manual (Page 34)

Series 9130 Operations Manual Rev - 33
Temp Zone Number
This option will allow the user to set the zone number for the assignment. The range is 0 – 5.
Temp Zone Offset
This option will allow the user to enter an offset for the assignment. The range is -4000 – 4000.
Furnace Setup
The Furnace Setup menu option is an administrative access only option. Do not make any adjustments on
the screen without first contacting Super Systems, Inc at 800-666-4330.
Date and Time
This value is the current date and time on the 9130 controller only (not the local computer or the touch
screen, if applicable). The time on the controller is displayed in the 24-hour format, so 8 = 8 AM, and 14 = 2
PM.
Note: The date and time of the touch screen can be changed (if necessary) by selecting the date and
time in the lower right corner on the touch screen, once the screen software has been shutdown and the
Windows™ desktop is visible. Then, at the CE screen the date and time can be changed by double taping
the time in the bottom right corner and setting it, then
select “apply”. For this to take effect the screen needs to be
rebooted; on the older TPC 642 displays the registry needs
to be saved under TPC Configuration icon, the Misc Tab and
then reboot the touch screen. The date and time that is
recorded on the flash card (and therefore the datalog data)
is the date and time of the Advantech display, not the
controller
.
Temperature
This value determines the specific temperature scale to be
used. It can be either Degrees
or degrees .
Temperature Instrument
Allows for a slave instrument (or internal) to be the defined temperature control device. The types of
instruments are: Temp Loop (Loop 1) – Loop 3, Instrument 1 – Instrument 25.
Event Instrument
Allows for a slave instrument (or internal) to be the defined event control device. The types of instruments
are: Internal, Instrument 1 – Instrument 25.
Quench Instrument
Allows for slave instrument (or internal) to be the defined quench control device. The types of instruments
are: Temp Loop (Loop 1) – Loop 3, Instrument 1 – Instrument 25.
End of Quench Event
Tells the programmer which event to signal end of quench (related to which relay it is assigned). The list of
possible values is: 0 – 15.
Quench Speed Event
Tells the programmer which event will signal the quench speed. The list of possible values is: 0 – 15.
Quench Run Event
Tells the programmer which event will signal quench run. The list of possible values is: 0 – 15.