Super Systems 9130 Series - Manual (Page 9)

Series 9130 Operations Manual Rev - 8
Approximate Box Dimensions 2.75" x 4" x 4.5"
Power Requirements 24VDC, 4 Watts
Digital Output Rating 300VAC / 1 AMP
Analog Output Load Rating 1000 Ohms (Total)
Controller Enclosure Rating IP10 – hand protected
Number of RS232 Ports Two (2)
Number of Ethernet Ports One (1)
Number of RS485 Host Ports One (1)
Number of RS485 Slave Ports Two (2)
Number of Internal Relays Eight (8)
Number of Analog Inputs Three (3)
Number of Analog Outputs Two (2)
Number of Digital Inputs Four (4)
Number of Control Loops One (1)
The Model 9130 is powered by 24 VDC, not LINE Voltage. Please be careful when connecting
power to this controller. Connecting anything other than 24 VDC will cause serious damage.
The variety of input and output combinations allows SSi to configure the Model 9130 to control
temperature.
The product is available in three different screen sizes. 3.5”, 5.7” and 12”.
Mounting
The SERIES 9130 Operator Interface mounts into a panel or on a plate by using the enclosed
mounting brackets. A rectangular cutout is required; the size of the cutout is determined by the
operator interface size. These units, along with an optional SSi SR3, 6, or 9 analog input board,
will mount on a commercially available DIN rail. This can be mounted on the sub-panel on the
side of an enclosure for the convenience of the control system.
!