Super Systems 9130 Series - Manual (Page 53)

Series 9130 Operations Manual Rev - 52
Alarm Text
This menu option will allow the user to configure the text for
the three main alarms on the 9130. Highlight the alarm to be
changed and click on the Edit button. This action will display
the on-screen keyboard, which will allow the user to modify the
alarm text. To save the changes to the alarm text, click on the
OK button. Clicking on the Cancel button will not save any of
the changes made.
Read/Write Data
This menu option is protected by the SSi special
passcode. Contact SSi at 800-666-4330 to obtain this
passcode before making any changes.
This menu option is used mainly for technical
support reasons. It will read the registers from the
9130 and display those registers on the screen. The
user will be able to read from and write to the 9130’s
registers. When the screen is first displayed, it will
read the first 100 registers from the 9130 and display
them in a column format. The top of the list will
show “0”, “10”, “20”, etc. These are the column
headers. Each value in the column will be a logical
increment of the header, where the first value in the
column equals the header value. For instance,
column “0” will start with register 0, which in the
picture has a value of “101”. The next value down is register 1, which has a value of “5”. The next value
down is register 2, which has a value of “1”, etc. So, column “40”, 4 values down is register is register 43,
which has a value of “9999”.
The number box in the top left of the screen is the beginning register to read from. This will default to 0
when the screen starts. To read registers 100 – 199, edit the value to read “100”.
Note – changing the
value will automatically begin the read process. This process could take a few seconds to complete .
The “Write offset” value will allow the user to write a specific value listed in the “Write value” box to the
register listed in the “Write offset” box. Click on the Write button to write the value to the register. Click on
the Return button to return to the
Configuration menu.