Super Systems 9130 Series - Manual (Page 75)

Series 9130 Operations Manual Rev - 74
Current Selection
Provides the option of 4-20 mA or 0-20 mA control. Clicking on this value will display an input box with a
drop-down list from which the user can select either of the two values listed above.
Offset and Range when assigned to a control loop
Inc : 0 = 4mA, 100 = 20mA
Dec : 0 = 4mA, -100 = 20mA
Example: if 4 – 20 mA = 800 mV - 1200 mV
Offset = 800 (starting point)
Range = 400
Passcode and Alarm
There are four levels of menus in the 9130
controller - Operator, Supervisor, Administrator,
and SSi Special.
Operator Level
These are functions typically handled by a furnace
operator and do not require a passcode. When an
operator is logged in, the lock on the toolbar will be
blue - .
Supervisor Level
These are functions typically used by a supervisor
and require a level 1 passcode. When a supervisor
is logged in, the lock on the toolbar will be gold - .
To change the level 1 passcode, or the web level 1 passcode, click on the “Level 1 Code” value (range is –
32768 to 32767) or the “Web Level 1 Code” value (range is 0 to 9999) and an input box will be displayed
where the user can select a new value.
Administrator
These are functions typically used by an administrator and require a level 2 passcode. When an
administrator is logged in, the lock on the toolbar will be green - . To change the level 2 passcode or the
web level 2 passcode, click on the “Level 2 Code” value (range is –32768 to 32767) or the “Web Level 2
Code” value (range is 0 to 9999) and an input box will be displayed where the user can select a new value.
SSi Special
These are functions that cannot be accessed without a passcode provided by Super System Inc. These
functions are vital to the operating modes of the controller and are typically never modified. When an SSi
Special user is logged in, the lock on the toolbar will be red - .
Web Change Enable
This option will determine if changes can be made over the 9130’s web page. Clicking on this value will
toggle between a 1 (Yes) and a 0 (No).
Programmer Alarm
Also available in this menu option is the availability to change the status of the relay contact with relation to
alarms. As shipped, the relay contact is open with no alarm. The user can choose either normally open or
normally closed.