T/c correction curves, Generic instruments – Super Systems 9130 Series User Manual
Page 55
Series 9130 Operations Manual Rev -
54
T/C Correction Curves
This menu option will allow the user to set up to three
TC correction curves for the 9130 controller, as well as
three auxiliary correction curves. Clicking on the
desired curve will display the curve edit form.
Note: If
the first “Temp” value and the first “Error” value are
both zero, then the curve will not be set
. The user can
enter up to ten “Temp”/“Error” combinations.
The range for the “Temperature” field is –32768 to
32767.
The range for the “Error” field is –32768.000 to
32767.000.
Generic Instruments
The generic instrument’s data will be stored in certain registers
on the host instrument, such as the 9130 controller. Each
instrument is allotted a certain set of registers, starting with
register 1000. To determine the beginning register, use the
following calculation: (100 * generic instrument’s number (1 –
16)) + 900. Therefore, instrument 1 would begin at register
1000: (100 * 1) + 900. Instrument 7 would begin at register 1600:
(100 * 7) + 900. Each instrument is allotted 100 registers,
therefore, instrument 1’s allotment is from register 1000 to
1099 on the 9130 controller, instrument 2’s allotment is from
register 1100 to 1199 on the 9130 controller, etc.
The
Generic Instrument Setups
menu is split into two parts: Coms, and Data. The screen lists the generic
instruments from Instrument 1 to Instrument 16. Select the desired instrument to configure, then choose
Coms or Data.
Coms
The three reads can be set up on this screen.
Read 1 Register, Read 2 Register, Read 3 Register
The Read
X
Register field will be the register in the 9130 controller that the instrument will read from. The
range is 0 – 32767.
Read 1 Count, Read 2 Count, Read 3 Count
The Read
X
Count field will be the number of successive registers to read. The range is 0 – 100.
Read 1 Storage Offset, Read 2 Storage Offset, Read 3 Storage Offset
The Read
X
Storage Offset field will be the offset in the generic instruments registers (1000 – 1099 for
Instrument 1, 1100 to 1199 for Instrument 2, etc). The range is 0 – 100.