Multi-Tech Systems 7500 - Manual (Page 101)

ION 7500 / ION 7600 User’s Guide Customizing the Vista Interface
Chapter 4 - Using ION Software Page 101
Analog Inputs/Outputs
The optional Analog I/O card must be installed on your meter for this diagram to
function. Depending on which option you chose for your card, the Analog I/O
diagram monitors either analog inputs or analog outputs, or it monitors both the
inputs and outputs.
Inputs
The meter’s analog inputs are monitored for the ScaledValu output register. This
value is displayed next to the appropriate port.
Outputs
The meter’s analog outputs are monitored for the Normalized output register. This
value is displayed next to its port.
Refer to the technical note Digital and Analog I/O for more information on analog
inputs and outputs and their associated output registers.
Revenue Test Mode
The Revenue Test Mode diagram shows TEST mode parameters. The energy and
demand values displayed only accumulate when the meter is in TEST mode. See
“Setup and Controls” on page 98 for instructions on placing the meter in TEST
mode.
Revenue Test Mode Values
◆ Accumulated values of active, reactive, and apparent energy (delivered,
received, and delivered + received)
◆ Sliding window and thermal demand for active power (delivered, received,
delivered peak, and received peak)
◆ All TEST mode values are cleared once you exit TEST mode
A red, flashing TEST mode label appears above the Energy label when the meter is
in Revenue TEST mode.
Customizing the Vista Interface
Standard Vista diagrams show much of the data that the factory-configured meter
measures and calculates. However, the factory-configured meter can provide
additional data that is not presented by default with these display tools. This data
can be added to the standard Vista diagrams by placing addition diagram objects
on them; or, you can create new user diagrams to display any additional data you
want.
Vista cannot be used to customize data displays on the ION meters themselves.
N OTE
Level 5 ION software authority (Supervisor) is required to create and configure new Vista diagrams. If you
do not have Level 5 password authority, contact your ION software administrator for assistance.