Multi-Tech Systems 7500 - Manual (Page 40)

Format Setup Menu ION 7500 / ION 7600 User’s Guide
Page 40 Chapter 2 - Using The Front Panel
Event Priority
You do not need to change this value for normal operation. This setting allows you
to assign a priority level to the Sag/Swell module events (from 0 to 255, 255 being
the highest priority).
Setting the EVENT PRIORITY value changes the EvPriority setup
register in the factory-configured Sag/Swell module.
Format Setup Menu
Format Setup contains values that allow you to set labeling and formatting
preferences for the front panel display.
Numeric Format
The Numeric Format sub-menu contains the following settings:
Digit Group
This specifies the symbols used to delimit thousands and the decimal place holder
(i.e. 1000.0 or 1,000.0 or 1 000,0). The default is 1000.0 (no commas, no spaces).
Volts Decimal
You can display voltage measurements to one, two, or three decimal places. The
default value is two decimal places.
Current Decimal
You can display current measurements to one, two, or three decimal places. The
default value is three decimal places.
Power Decimal
You can display power measurements to one, two, or three decimal places. The
default value is three decimal places.
General Format
The General Format sub-menu contains the following settings:
Phase Label
You can apply phase labels in any of the following six variations: ABC, RST, XYZ,
RYB, RWB, and 123. The default label is ABC.
PF Symbol
You can choose Power Factor symbols to be: LD/LG (lead/lag), +/– (positive/
negative), or CAP/IND (capacitive/ind
uctive). The default symbols are LD/LG.
Date Format
You can have the front panel express the date in any of these formats: MM/DD/
YYYY, DD/MM/YYYY, and YYYY/MM/DD. The default is MM/DD/YYYY.
Show DST
You can choose whether or not to display Daylight Savings Time (DST) on the
front panel. The default is Display DST.