Multi-Tech Systems 7500 - Manual (Page 271)

ION 7500 / ION 7600 User’s Guide Configuring your Meter
WebMeter Internal Web Server Feature Technical Note Page 271
Configuring your Meter
Use the Setup page to configure your meter’s WebMeter feature.
If security is enabled, as a security measure, you must enter a user name and the
meter password when you change a parameter. Note that security is enabled by
default. Contact your ION software administrator for a user name and the meter
password.
N OTE
If meter configuration via a web browser is disabled, and you attempt to configure the meter, an error
message displays. To enable meter configuration via a web browser, see “Enabling/Disabling Meter Web
Browser Configuration” on page 277.
Since every meter family will have different default web pages, the following
instructions may not be exactly accurate for your meter.
Using the Setup Page
Use this page to change your default web page’s power meter measurement
parameters.
Configuring your meter with the Setup page:
1. Start your web browser.
2. Type the meter’s IP Address into the browser Address field. The Operation
screen appears.
N OTE
If Advanced Security is enabled on your ION 8000 Series meter, you must enter a user name and
password before the Operations screen appears. To configure your meter with a web browser, your user
name and password must have “Full Config Access” on the meter.